Modifying a View Filter

You can modify a filter box by editing its offset, adding a part to the box, or removing part from the box after its creation.

Before you begin: A structural product representation containing a drawing sheet with a view generated using view filter.
See Also
Creating a View Filter
  1. To modify the offset value, perform any one of the following operations:
    • Hover over the face and drag the offset arrow.
    • Right-click a face of the box and select Edit. Enter the required offset value.
    • Right-click a face of the box and select Up to Plane. Select the required plane.
  2. To add a part to the box:
    1. Right-click a face and select Add Part.
    2. Select a part from the 3D area.
  3. To remove a part from the box:
    1. Right-click a face and select Remove Part.
    2. From the list, select a part to remove.
      The selected part is highlighted in the 3D area.
      Note: If the box is created by selecting a part, removing the part from the list deletes the box.