Simulate Section

The Simulate section of the action bar provides commands for you to execute and view the results of your simulation.

This page discusses:

Play Animation
See Flyout for Viewing Options.
Report
Creates a report document that summarizes the results of your simulation.
See Creating Reports.
Rendering Settings
Configures display of geometry associated with the simulation, including products or parts that did not participate in the simulation.
See Controlling Geometry Rendering.
Results Storage
Specifies where simulation results are stored.
See Setting the Results Storage Mode.
Model and Scenario Checks
Checks for errors in the current model and scenario.
See Performing Model and Scenario Checks.
Simulation Checks
Complete the Model and Scenario Checks, and check the simulation for any issues likely to prevent it from running successfully.
See Performing Simulation Checks.
Simulate
See Flyout for Simulate.

Flyout for Viewing Options

Play Animation
Animates all active plots.
See About Animation.
Show Min/Max Values
Highlights where the maximum and minimum values occur.
See Controlling the Display of Maxima and Minima.
Plot Sectioning
Creates a cut through the model to view its interior.
See Creating Cutting Surfaces.
Display Group
Configures the options to remove/keep portions of the model from the display.
See Display Groups.

Flyout for Simulate

Simulate
Runs a simulation for your current model and scenario.
See Running a Simulation from an App.
Simulate Options
Sets network options for execution on 3DOrchestrate Stations.
See Setting Remote Simulate Options for 3DOrchestrate.