Creating Hems

You can generate hems from a spine and a profile.


Before you begin: Create a wall.
See Also
About the Creation of Swept Walls
About the Selection of the Spine
  1. From the Model section of the action bar, click Hem .
  2. Select an edge.

    In the Spine context menu, select Select tangent continuous edges to select all tangentially contiguous edges forming the spine.

  3. To define the flange parameters, do the following:
    1. Enter a value for the length.
    2. Enter a radius for the angle.


  4. From the Position list, select the support type.

    This option lets you trim edges that lie on planar supports only.

  5. Optional: To reverse the direction of the hem, click Reverse .