|
GTE
|
General Time Element (GTE) standard time analysis system: Used for
Generic purposes only and could use to sum up other time
analysis using their own codes. |
| General
|
Aspects of the UI and the window display.
|
| Single and Small Batch Production - MEK
|
Measure Economical Kind (MEK) standard time analysis system: Is a
building block system that you can use for both basic and
standard operations. Use for small number of items and
single unit production as well as other infrequently
performed tasks previously considered too costly or
difficult to measure. |
| Maynard Operation Sequence Technique - MOST
|
Maynard Operation Sequence Technique (MOST) standard time analysis
system: Is optimal for short processes with only small hand
motions. Note:
When migrating from E5, use the old format by
changing the environment variable
DEL_SHOW_OPTION_FOR_MOST_FORMATS.
In the MOST Time Motion Study, when a partial
frequency (PF) applies to a part of a sequence, show
it by appending "-" and then the PF. You have the
option to display it with brackets (A1B1G1) A1B1P1A1
3 by changing the environment variable.
|
| Methods-Time Measurement 1 - MTM1
|
MTM1 (Method Time Measurement One)
standard time analysis system: This analyzes the methods
used to perform any manual operation or task and, as a
byproduct of that analysis, define the standard time in
which a worker can complete that task. |
| Methods-Time Measurement 2 - MTM2
|
MTM2 (Method Time Measurement Two)
standard time analysis system: Same as MTM1 but for longer
work cycles. |
| Ready Work Factor - RWF
|
RWF (Ready Work Factor) standard time
analysis system: An elemental time system for compiling time
standards to establish the expected productivity of the
human when performing useful manual and mental work.
|
| Standard Allowed Minute - SAM
|
SAM (Sequence-based Activity Method) standard time analysis system:
This is a synthetic system that measures manual type of work
based on predefined sequential activities. |
| Stand from Sitting Position - STD
|
STD (Standard Data) standard time analysis system: These are basic
values derived from the MTM basic system. Use this hand
system for products with a high number of items. |
| Universal Analyzing System -UAS
|
Universal Analyzing System (UAS) standard time analysis system: Is a
building block system that uses both the basic and standard
operations. This system is for use in environments that
exhibit the characteristics of batch production. |
| MODular Arrangement of Predetermined Time Standards - MODAPTS
|
Modular Arrangement of Predefined Time Standard (MODAPTS): These
generally apply to repetitive tasks with short to
medium-length cycle times. MODAPTS calculates the time it
takes to complete a job when working at a standard pace. It
also acts as the foundation for methods analysis and
workplace optimization, and measures time used in Line
Balancing and Job costing by providing direct labor minutes. |
| Value Added
|
Value Added Category system: A feature that does not depend on the
STM or the calculated values,
and is applicable only to a single hand process such as the
Universal Analyzing System and Standard Data. |
> Preferences, and then click the All Preferences tab.