Context Toolbars


	Construction Element Converts the sketcher element into construction element. See Converting Standard into Construction Elements.
	Geometrical Element Converts the sketcher element into geometrical element. See Converting Standard into Construction Elements.
	Chamfer Creates a chamfer between the two intersecting curves. See Creating Chamfers.
	Corner Creates a corner. See Creating Corners.
	Trim Trims the unnecessary part of a curve based on a relimiting element. See Trimming Elements.
	Break Breaks the elements. See Breaking Elements.
	Circle from Point Creates a circle. See Creating Circles.
	Offset Duplicates the selected element by offsetting. See Duplicating 2D Elements Using Offset.
	Auto Search Searches and selects the different elements of the profile. See Performing Auto-Search on Profiles.
	Auto Search with Tangent Propagation Searches and selects the elements that are tangential to the profile. See Performing Auto-Search on Profiles.
	Intersect 3D Elements Intersects 3D elements with the sketch plane.
	Project 3D Elements Projects 3D elements onto the sketch plane.
	Project 3D Silhouette Edges Projects silhouette edges of 3D elements onto the sketch plane.
	Horizontal Creates a horizontal constraint on the selected line.
	Vertical Creates a vertical constraint on the selected line.
	Group Groups together to create a rigid set. See Grouping Sketch Elements Together.
	Select geometrical elements Selects the geometrical elements that compose the group. See Grouping Sketch Elements Together.
	Fix Fixes the position and the size of the element by creating a fix constraint.
	Activate Activates the constraint so as to be considered by the solver of constraints.
	Deactivate Deactivates the constraints so as not to be considered by the solver of constraints.

Notes:

The commands available in the context toolbar change based on the selected elements.

The possible commands proposed are based on the type of selected elements and the context in which the element is itself.

For example, if the element is already constrained, or if the element is shared by another element, the available commands will be different for a single element, and an element shared by another element.

The following table depicts the different commands proposed by Sketcher app in the context toolbar according to the selection:


Selection	Command	Conditions for selection
One point		Depending on the geometry type, standard or construction, the command available is Construction Element or Geometrical Element . If the point is used as an extremity of curve, it is possible to isolate this point using Break. If the geometry is not already fixed, it is possible to create a Fixconstraint. If the point is not shared by another geometry, it is possible to create a circle . The point is used as a center of the circle and transformed into a construction element. If an element is shared by two curves, it is possible to create a corner or a chamfer . If the geometry is not already a part of a group, it is possible to create a Group constraint. Trim and Break commands are available for all curves except for Conic or Connect curve. Auto Search is available if an element is connected to another element. Auto Search with Tangent Propagation is available if an element is tangential to another element. Horizontal constraint is available only for a line that is not constrained horizontally already. Vertical constraint is available only for line that is not constrained vertically already. Offset constraint is available only when manifold input or wire is not self intersecting. Deactivate constraint is available only when a constraint is active. Add , Subtract , and Intersect Location are available only on the selection of at least one of the several intersecting closed profiles.
Two points
Several points
One curve
Two curves
Several curves
One constraint
One or several profiles
Curvilinear Constraint