Fabrication Rule Table

This rule table allows you to create features between split plates of a panel.

This page discusses:

See Also
Profile Detail Table
Curved Profile Table
Weld Detail Table
Shrinkage Ratio Table
Margin List

General Information

If the split plate of the panel is matched with thickness, it returns Code to create features from the Weld Detail Table when you click Update IPM or Synchronization.

Column Information

Weld_Type: Is always Butt, because it is only for the split plate of the panel.

IP1_Type: Is always Plate.

IP1_Thickness_Section: Thickness of first split plate.

IP2_Type: Is always Plate.

IP2_Thickness_Section: Thickness of second split plate.

IP1_Edge_Margin: Code for first split plate to be used in Weld Detail Table.

IP2_Edge_Margin: Code for second split plate to be used in Weld Detail Table.

Weld_Type IP1_Type IP1_Thickness_Section IP2_Type IP2_Thickness_Section IP1_Edge_Margin IP2_Edge_Margin
Butt Plate 10 Plate 10 S_10_0 S_10_0
Butt Plate 10 Plate 20 S_10_0 S_10_0
Butt Plate 10 Plate 30 S_10_0 S_10_0
Butt Plate 10 Plate 40 S_10_0 S_10_0