Shrinkage Ratio Table

This rule table allows you to create shrinkage features with specified values.

This page discusses:

See Also
Profile Detail Table
Curved Profile Table
Weld Detail Table
Margin List
Fabrication Rule Table

General Information

If the plate/panel is matched with material and thickness, the shrinkage feature is created with the given value when you click Shrinkage Planning.

In Edit Feature, you are able to see values between the minimum and maximum specified by an interval.

Column Information

Material: Material of Plate/Panel.

Thickness: Thickness of Plate/Panel.

OuterContour Minimum: Minimum ratio value of Outer contour.

OuterContour Maximum: Maximum ratio value of Outer contour.

OuterContour Intervals: Interval between Minimum and Maximum ratio value of Outer contour.

OuterContour Default: Default ratio value when creating the shrinkage of the Outer contour.

MarkingLine Minimum: Minimum ratio value of Marking Line.

MarkingLine Maximum: Maximum ratio value of Marking Line.

MarkingLine Intervals: Interval between Minimum and Maximum ratio value of Marking Line.

MarkingLine Default: Default ratio value when creating the shrinkage of the Marking Line.

Material Thickness OuterContour Minimum OuterContour Maximum OuterContour Intervals OuterContour Default MarkingLine Minimum MarkingLine Maximum MarkingLine Intervals MarkingLine Default Shrinkage per Impacting Object
STEEL A36 10mm 0.8 1.2 0.05 0.8 0.8 1.2 0.05 0.8 0.1mm
STEEL A36 20mm 0.8 1.2 0.05 0.8 0.8 1.2 0.05 0.8 0.2mm
STEEL A36 30mm 0.8 1.2 0.05 0.8 0.8 1.2 0.05 0.8 0.3mm
STEEL A36 40mm 0.8 1.2 0.05 0.8 0.8 1.2 0.05 0.8 0.4mm
STEEL A46 10mm 0.8 1.2 0.05 0.8 0.8 1.2 0.05 0.8 0.5mm
STEEL A46 30mm 0.8 1.2 0.05 0.8 0.8 1.2 0.05 0.8 0.6mm
STEEL A42 3mm 0.8 1.2 0.05 0.8 0.8 1.2 0.05 0.8 0.7mm
STEEL A42 5mm 0.8 1.2 0.05 0.8 0.8 1.2 0.05 0.8
STEEL A42 10mm 0.8 1.2 0.05 0.8 0.8 1.2 0.05 0.8
STEEL A42 15mm 0.8 1.2 0.05 0.8 0.8 1.2 0.05 0.8
STEEL A42 20mm 0.8 1.2 0.05 0.8 0.8 1.2 0.05 0.8
STEEL A42 25mm 0.8 1.2 0.05 0.8 0.8 1.2 0.05 0.8