Profile Detail Table

This rule table allows you to create features on profiles.

This page discusses:

See Also
Margin List
Curved Profile Table
Weld Detail Table
Shrinkage Ratio Table
Fabrication Rule Table

General Information

The row has code from the profile action rule that creates features on the profile.

Column Information

Code: ID from the Profile Action rule.

EP_Web_Start: Edge preparation on web start of profile.

EP_Flange_Start: Edge preparation on flange start of profile.

EP_Web_End: Edge preparation on web end of profile.

EP_Flange_End: Edge preparation on flange start of profile.

EP_Bottom: Edge preparation on bottom of profile.

PM_Web_Start: Positive margin on web start of profile.

PM_Flange_Start: Positive margin on flange start of profile.

PM_Web_End: Positive margin on web end of profile.

PM_Flange_End: Positive margin on flange end of profile.

PM_Bottom: Positive margin on bottom of profile.

NM_Web_Start: Negative margin on bottom of profile.

NM_Flange_Start: Negative margin on bottom of profile.

NM_Web_End: Negative margin on bottom of profile.

NM_Flange_End: Negative margin on bottom of profile.

NM_Bottom: Negative margin on bottom of profile.

IsShrinkage: Subtype of margin whether it is shrinkage information or not.

Code EP_Web_Start EP_Flange_Start EP_Web_End EP_Flange_End EP_Bottom PM_Web_Start PM_Flange_Start PM_Web_End
S_10_0 Single_Bevel Single_Bevel Single_Bevel Single_Bevel 10mm 5mm 0mm
S_20_0 Single_Bevel Single_Bevel Single_Bevel Single_Bevel 20mm 0mm 0mm
PM_Flange_End PM_Bottom NM_Web_Start NM_Flange_Start NM_Web_End NM_Flange_End NM_Bottom IsShrinkage
0mm 0mm 0mm 0mm 0mm 0mm 0mm
0mm 0mm 0mm 0mm 0mm 0mm 0mm Y
0mm 0mm 0mm 0mm 0mm 0mm 0mm
0mm 0mm 0mm 0mm 0mm 0mm 0mm
0mm 0mm 0mm 0mm 0mm 0mm 0mm