Replacing Route Elements

You can change the composition of a branch route.

This task describes how to replace a support by a passing point. The scenario is identical for all route elements.

Note: When replacing a passing point with another route element, the passing point is removed from the route but the geometrical point is not deleted by default. To delete geometrical points while replacing passing points, use the Unused Point Deletion option.


Before you begin:
  • Activate an electrical branch geometry, and then select a branch in the work area.
  • From the Branch section of the action bar, click Immersive Branch Definition .

    The Auto Routing Mode is activated and yellow bullets appear on route elements.

See Also
About Immersive Branch Definition
  1. In the work area, click a yellow bullet to select a route element (a support in our example).
    • The Manual Routing Mode is activated.
    • The Robot is snapped onto the selected element.


  2. Substitute the support for a passing point:
    1. In the context toolbar, click Replace routing element .
    2. In the 3D area, select the point.
    The support is removed from the route which is updated accordingly.

  3. To cancel your manipulations, press Escape or close the Branch Properties panel.
  4. To validate your manipulations, click in the 3D area or press Enter.