Editing Parts in an MCO

You can edit new part revision connections for an MCO in the Create state. You can edit only the make/buy code for a connected part.

The entered make/buy code cannot violate the design-purchase decision given in the part. If the part has been marked as ‘Purchase,’ then the make/buy code cannot be set as ‘Make.’

Before you begin: Access the Affected Part Revisions page of an MCO. See Affected Part Revisions.
See Also
Adding Parts to an MCO
  1. From the page toolbar, click Enable Edit.
  2. Do one of the following:
    • Click the Make/Buy cell that you want to change and select a value from the list: Make, Buy, or Unassigned.
    • Change the Make/Buy attribute for multiple selected parts simultaneously using the Mass Update menu.
      1. Select Make/Buy from the Mass Update menu.
      2. Select a value from the list from the list: Make, Buy, or Unassigned.
      3. Click Apply to Selected to apply the change only to selected parts or click Apply to All to apply the change to all parts.
  3. Click Save.

The Affected Part Revisions page reflects the make/buy changes.