Reinforcement Section

The Reinforcements section of the action bar provides commands for creating rebars, checking for interferences in a single rebar layer or between rebars layers, generating a rebar report including relevant information for each type of rebar and each rebar layer, showing or hiding wire and layers.

This page discusses:

Rebar Creation
Creates standard or parametric 3D rebar geometry from various creation modes (Template, Wire selection, Strap, Mesh).
See Creating Rebars.
Rebar Group
Creates groups of rebar layers in a same section. These layers follow the same pattern.
See Creating Rebar Groups in Sketch Mode.
Rebar Transformations
Performs geometric transformations on the Rebar Layer features such as translate, rotate, symmetry, split, … without losing the rebar specifications.
See Performing Transformations.
Rebar Accessories
Adds couplers between rebar layers or rebar split.
See Adding Couplers on Rebars.
Rebar Interference
Checks interferences between two sets of rebar layers or within the same rebar layer.
See Running an Interference Analysis.
Barmark Management
Manages the numbering of rebar layers.
See Defining Bar Marks.
Export Rebar Report
Exports rebar layer information in a report to the format of your choice.
See Creating Reports.
Show Rebar Layer
See Flyout for Showing Rebar Layer.
Show Rebar Wire
See Flyout for Showing Rebar Wire.
Unfold
Unfolds the 3D shape and folds it again.

Flyout for Showing Rebar Layer

Show Rebar Layer
Shows all the rebar layers in the active part.
See Creating Rebars.
Hide Rebar Layer
Hides all the rebar layers in the active part.
See Creating Rebars.

Flyout for Showing Rebar Wire

Show Rebar Wire
Shows all the rebar wires in the active part.
Creating a Rebar.
Hide Rebar Wire
Hides all the rebar layers in the active part.
Creating a Rebar.