Creating a Rebar Wire by Picking Points

You can design a rebar layer from a curve by selecting Wire selection. The Wire selection creation mode allows you to design a rebar by creating a curve from picking points in the dedicated CATIA Rebar Routing 3D Design app.

Before you begin:
  • Create a concrete part with a rebar object to help you organize your concrete structure.
  • Create the rebar features inside a geometrical set under a 3D shape.
  • Define the working context on the created geometrical set that will accommodate the rebar features.
Note: For more information, see Rebar Features Creation: Recommendation.
See Also
Creating Rebars on the Fly
Creating an Additional Wire
About the Wire Selection Mode
  1. From the Reinforcement section of the action bar, click Rebar Creation .
  2. Click Wire selection to define a rebar layer based on wires.
  3. Click Picking Point .
    The Picking Point rebar creation mode is turned on.
  4. Create a rebar by picking points. For more information, see Creating a Rebar by Picking Points.