Creating Rebars on the Fly

This section describes how to design the bar wireframe directly from a dedicated CATIA Rebar Routing 3D Design app accessible directly from the Rebar Creation command.


In this section:

About Rebar Routing 3D Design Options
Creating a Rebar by Picking Points
Modifying Rebar Length
Routing with the Offset Manipulator
Modifying Bend Angle
Modifying Rebar Orientation
Deleting a Node
Replacing a Node
Modifying a Bend or a Segment
Translating a Rebar Segment
Routing with Alternate Paths
Create a Slope on a Rebar
Routing along a Surface