Structure Section


	Path Segment Member See Flyout for Path Segment Member.
	Trim Member Trims the corners of the members. See Trimming Members.
	Cutout You can create a cutout on one or more members using a closed sketch or single body. See Creating Cutouts on Members.
	Structure Section See Creating Structure Sections.
	Cut-List Creates a summary of all the structure members in a tabular format similar to the BOM table. See Creating Cut Lists.
	Plates You can add plates at the bottom of the structure members for support using the Plate feature. See Plates, Gussets, and End Caps.
	Gussets You can create Gussets and add them as a stiffener between the members. See Creating Gussets.
	End Caps You can close off the open members using the End Cap feature. See Creating End Caps.
	Split Member See Flyout for Split Member.

Flyout for Path Segment Member


	Path Segment Member Creates members using sketch entities. See Creating Path Segment Members
	Reference Plane Member Creates members along the intersection of two or more planes. See Creating Reference Plane Members.
	Face Plane Intersection Member Creates members along the intersection of faces or surfaces. See Creating Members at the Intersection of Faces and Planes.
	Point Based Members Creates members starting at a point and ending up to a specified point, length, or plane. See Creating Point-Based Members.
	Between Members Creates members in between two existing members. See Creating Members Between Members.


	Split Member You can split a member in to multiple small members using this feature. See Splitting Members
	Merge Member You can merge multiple members into a single member. See Merging Members.