Markups are changes to either a part's properties or a part's BOM. Changes to the part's
properties are "Item Markups". Changes to the part's BOM are "BOM Markups". This section
explains how to work with both types of markups.
No markup can be created on a part unless the part is in either the In Work or Released state. Markups
created for a part that is in the Release state can be applied
only when the part is revised.
While creating BOM Markup on a part that is in the Development release phase, you can associate a change action (CA) to the markup.
Markups must be manually applied to parts that are in the In Work state. Parts cannot
be promoted from In Work to Frozen if there is any
approved markup that has not been applied.