Results Section

The Results section of the action bar provides commands for requesting output from your simulation, running the simulation, and viewing its results.

This page discusses:

Flyout for Results Storage
Flyout for Simulate
Flyout for Comparison Tools


	Results Storage See Flyout for Results Storage.
	Simulate See Flyout for Simulate.
	Solver Options Edits the parameters that control the solver. These options are for advanced users only. See Solver Options.
	Sensor Determine the minimum, maximum, or maximum absolute values for a selected variable. See Creating Output Sensors in Physics Results Explorer.
	Play Animation Animates all active plots. See About Animation.
	Show Min/Max Values Highlights where the maximum and minimum values occur. See Controlling the Display of Maxima and Minima.
	View Cut Creates a cut through the model to view its interior. See Creating Cutting Surfaces.
	Display Group Configures the options to remove/keep portions of the model from the display. See Display Groups.
	Comparison Tools See Flyout for Comparison Tools.
	Report Creates a report document that summarizes the results of your simulation. See Creating Reports.
	Rendering Settings Configures display of geometry associated with the simulation, including products or parts that did not participate in the simulation. See Controlling Geometry Rendering.

Flyout for Results Storage


	Results Storage Specifies where simulation results are stored. See Setting the Results Storage Mode.
	Delete Simulation Results Clears the results and some of their contents associated with the simulation. See Deleting Simulation Results.

Flyout for Simulate


	Simulate Specifies the parameters for running the simulation and then runs it. See About Simulation Configuration.
	Simulate Options Sets network options for execution on 3DOrchestrate Stations. See Setting Remote Simulate Options for 3DOrchestrate.

Flyout for Comparison Tools


	Single View Displays plots in a single view. See Displaying Multiple Plot Views Simultaneously.
	Two Columns Displays plots in two views, split vertically. See Displaying Multiple Plot Views Simultaneously.
	Main View on Top Displays plots in three small views on the bottom and a larger view on the top. See Displaying Multiple Plot Views Simultaneously. See Displaying Multiple Plot Views Simultaneously.
	Main View on Right Displays plots in three small views on the left side and a larger view on the right side. See Displaying Multiple Plot Views Simultaneously. See Displaying Multiple Plot Views Simultaneously.
	Two Rows Displays plots in two views, split horizontally. See Displaying Multiple Plot Views Simultaneously. See Displaying Multiple Plot Views Simultaneously.
	Four Views Displays plots in four equally sized views. See Displaying Multiple Plot Views Simultaneously.
	Multi-View Settings Customizes layouts and their synchronization settings. See Displaying Multiple Plot Views Simultaneously. See Displaying Multiple Plot Views Simultaneously.