Surfaces Section

The Surfaces section of the action bar provides.

This page discusses:

Projection Curve
See Flyout for Projection.
Extrude Surface
Creates a surface extrude.
See Extruding a Surface.
Revolve Surface
Creates a surface extrude by revolving a two-dimensional object about an axis.
See Creating a Revolved Surface.
Sweep Surface
Creates a surface extrude by moving a profile along a path.
See Creating a Sweep Surface.
Loft Surface
Creates a surface loft by moving profiles along guide curves
See Creating a Loft Surface.
Fill Surface
Fills a gap in a component.
See Creating a Filled Surface.
Knit
Combines two or more adjacent surfaces.
See Flyout for Knit.
Trim Surface
Trims geometry to create a new part.
See Trimming a Surface.
Offset
Offsets faces or bodies.
See Offsetting a Face or Body.
Extend Surface
Extends the selected surfaces.
See Extending a Surface.
Ruled Surface
Creates Ruled Surface from an edge of an existing model.
See Creating a Ruled Surface.

Flyout for Projection

Projection Curve
Creates curves from one of more elements projecting to a plane.
See Creating Projection Curves.
Intersection Curve
Creates curves using the intersect of surfaces.
See Creating Intersection Curves.
Through Point Curve
Creates curves using a series of points.
See Creating Through Point Curves.
Helical Curve
Creates spiral curves that you can use as a path for swept and lofted features.
See Creating Helical Curves.

Flyout for Knit

Knit
Combines two or more adjacent surfaces.
See Knitting and Unknitting Faces or Bodies.
Unknit
Disconnects two or more adjacent surfaces.
See Knitting and Unknitting Faces or Bodies.