Specifying Existing Materials and Lots

You can choose the existing materials and lots to test during a study. You can choose these when you start defining a study, add to them during the design, or after you specify the tests, time points, and storage conditions.

See Also
Introductory Concepts
Products, Materials, Batches, and Lots
Study Data
Phases of a Study
Cloning a Study
  1. Select the Materials tab of a study being edited.
    This displays a tab where you can define the materials and their lots to test.
  2. Click .
    This adds a new row to the materials table.
  3. For each material:
    1. Select the Study Material to use.
    2. Select the Manufacture LotID (Receipt Lot ID) of the material to use.
    This displays the amounts of the lots you chose in the Available/Requested Amount column. For each row, if this is less than the amount required for the test design of the study, the Available/Requested Amount cell displays a warning icon with a tooltip message.
  4. Optional: Click to remove a material that you no longer require.
  5. If the study design is not yet defined, proceed to define storage conditions and design tests.

    For more information, see Defining Storage Conditions and Designing Tests.

  6. To save your changes to the study, click Apply.

The Materials tab of the study displays the lots of your selected materials and their amounts. You can change the order of the materials in the study. For more information, see Organizing Materials.

Tip: Click to open the Summary Amount view, for each material this reports the amount required for each storage condition, test, and time point, as well as the total amount. For more information, see Summary Amount.