Die Face


	Fill Surface Fills holes generated by inner boundaries of surfaces. See Filling Holes on Surfaces.
	Convex Polygon Computes a convex polygon that contains the projected boundary of the stamped part. See Computing a Convex Polygon.
	Surface Extension Extends a surface on defined working areas. See Creating a Surface Extension.
	Connect Surface Fills the gap between extended surfaces. See Creating a Connect Surface.
	Fill Concave Area Fills a concave area. See Filling a Concave Area.
	Fillet Connect Creates fillets to fill or extend surfaces. See Creating a Fillet Connect.
	Profile Creates profiles on selected vertices of the part boundary. See Creating Profiles.
	Addendum Surface Creates addendum surfaces to represent the simple preformed sheet of metal that connects the stamped part to the binder. See Creating Addendum Surfaces.
	Wall Surface Creates wall surface to represent the simple preformed sheet of metal that connects the stamped part to the binder. See Creating Wall Surfaces.
	Wall Surface Manager Creates wall surfaces from sketch to represent the simple preformed sheet of metal that connects the stamped part to the binder. Detects intersections between wall surfaces and creates fillets. See Creating a Wall Surface Manager.
	Surface Offset Creates a local offset on a surface, using a wireframe section. See Creating a Local Offset on a Surface.
	Pivot Flange Creates a flange with a pivot curve, to compensate the springback effect. See Compensating Flange Springback Effect.
	Fillet Search Searchs and extracts fillets on a surface. See Searching Fillets.
	Fillet Radius Reduction Reduces fillet radius by a given value, percentage or to a specific target radius. See Reducing the Radius of Fillets.
	Boundary Partition Boundary Partition creates boundary sections using a sketch or points on curve to stabilize inputs for the detailed design.
	Variable Offset Curve Variable Offset Curve creates an variable parallel curve on a support.
	Fillet Based Projected Curve With Angle Fillet Based Projected Curve With Angle creates a curve that is the result of an intersection between a tangential sweep based on a circular sweep and a bottom plane or bottom shell.
	Boundary Analysis Creates an analysis of boundaries in order to extend them. See Creating a Boundary Analysis Manager.
	Surface Extension Manager Creates a Surface Extension Manager based on Analysis Boundary See Creating a Surface Extension Manager.