Context Toolbars

Draw


	Draw on Grid Lets you draw on a smart grid that helps you create and precisely position your drawing relative to underlying geometry. See About the Support Plane.
	Draw in 3D Lets you draw in 3D. See About the Support Plane.
	Open Profile Lets you draw lines, arcs, points and spline curves. See Drawing Lines and Arcs and Drawing Spline Curves.
	Closed Profile Lets you draw circles, rectangles, ellipses and polygons. See Drawing Circles, Rectangles, Ellipses and Polygons
	Line See Drawing Lines and Arcs
	Arc Lets you draw an arc using the Tangent Arc or the Three-Point Arc command. See Drawing Lines and Arcs
	Spline See Drawing Spline Curves
	Point See Drawing Lines and Arcs
	Circle See Drawing Circles, Rectangles, Ellipses and Polygons
	Rectangle Lets you draw a rectangle by clicking to locate the two opposite corners (Corner Rectangle ) or by clicking to locate the center, and then dragging and clicking to set the four edges (Center Rectangle ). See Drawing Circles, Rectangles, Ellipses and Polygons
	Ellipse See Drawing Circles, Rectangles, Ellipses and Polygons
	Polygon See Drawing Circles, Rectangles, Ellipses and Polygons
	2 corner Rectangle See Drawing Circles, Rectangles, Ellipses and Polygons.
	Centered Rectangle See Drawing Circles, Rectangles, Ellipses and Polygons.
	Undo Reverses your last action. Repeat as many times as required. Some actions cannot be undone because they require too much memory. See Smart Grid.


	Local Mode Lets you work on a face, a surface, an edge or a point. This is the default mode.
	Global Mode Extends the selection to all parts of the geometry in contact with the selected face or surface. Lets you work on a whole shape.
	Import Geometry Imports geometry from another app or from another CAD system. See Recognizing Geometry.
	Minimum with no relief See Creating a Wall on Edge.
	Maximum See Creating a Wall on Edge.
	Linear See Creating a Wall on Edge.
	Tangent See Creating a Wall on Edge.
	Wall On Edge - BendMode See Creating a Wall on Edge.
	Wall On Edge - BendMode Clearance See Creating a Wall on Edge.
	Wall on Edge Basic Move See Modifying Walls.
	Wall on Edge Independent Move See Modifying Walls.
	Normal Extrapolation See Modifying a Wall.
	Tangent Extrapolation See Modifying a Wall.
	Disconnect See Creating Walls from Extrusions.
	Bend Radius modification See Modifying a Bend.
	Bend Angle Basic Modification See Modifying a Bend.
	Bend Angle Independent Modification See Modifying a Bend.
	Translate See Modifying Faces.
	Offset See Modifying Faces.
	Chamfer Cuts off a sharp edge. See Create a Chamfer or a Corner.
	Corner Rounds a sharp edge. See Create a Chamfer or a Corner.
	Move Element See Move a Lateral Sharp Edge.
	Move Vertex See Modifying an Edge.
	Check Overlapping C hecks if the walls on edge that you have created do not overlap. See Checking Overlapping.
	Switch to fold or unfold view See Folding/Unfolding a Part.