Refine Section

The primary area of the Refine section provides commands for creating cutouts, corners, chamfers and stamps.

This page discusses:

Flyout for Creating a Hole
Flyout for Creating Stamps
Flyout for Creating Specific Stamps


	Positioned Sketch Creates a positioned sketch. See Creating a Positioned Sketch from the Part Design User's Guide.
	Corner Relief Creates a local corner relief between two flanges. See Creating Local Corner Relieves.
	Corner Creates a corner to round off sharp edges of a 3D shape. See Creating Corners.
	Chamfer Creates a chamfer to cut off sharp edges of a 3D shape. See Creating Chamfers.
	Cutout Creates a cutout by extruding a profile and removing the material resulting from the extrusion. See Creating Cutouts.
	Hole See Flyout for Creating a Hole.
	Surface Stamp See Flyout for Creating Stamps.
	Louver See Flyout for Creating Specific Stamps.

Flyout for Creating a Hole


	Hole Creates a hole. See Creating Holes.
	Circular Cutout Creates a circular cutout. See Creating Circular Cutouts.
	Thread/Tap Creates a thread or a tap on a cylindrical element. See Creating Threads and Taps.

Flyout for Creating Stamps


	Surface Stamp Creates a surface stamp. See Creating Surface Stamps.
	Bead Creates a local deformation in a wall using a spine. See Creating Beads.
	Curve Stamp Creates a curve stamp by specifying punch parameters. See Creating Curve Stamps.
	Flanged Cutout Creates a flanged cutout by specifying punch parameters. See Creating Flanged Cutouts.
	Flanged Hole Creates a flanged hole by specifying punch parameters. See Creating Flanged Holes.
	Circular Stamp Creates a circular stamp by specifying punch parameters. See Creating Circular Stamps.

Flyout for Creating Specific Stamps


	Louver Creates a louver by specifying punch parameters. See Creating Louvers.
	Bridge Creates a bridge by specifying punch parameters. See Creating Bridges.
	Stiffening Rib Creates stiffening ribs by specifying punch geometrical parameters. See Creating Stiffening Ribs.
	User Stamp Creates stamps with punches or punches and dies. See Creating User-Stamps.
	Dowel Creates a dowel by specifying punch parameters. See Creating Dowels.