Prismatic Machining Section

The Prismatic Machining section of the action bar provides commands for creating Prismatic Machining operations.

This page discusses:

Prismatic Machining Area
See Flyout for Creating Prismatic Machining Areas.
Prismatic Roughing
See Flyout for Creating Prismatic Roughing Operations.
Profile Contouring
Creates a Profile Contouring operation with the mode Between Two Planes.
See Creating a Profile Contouring Operation: Between Two Planes.
Facing
Creates a Facing operation.
See Creating a Facing Operation.
Pocketing
See Flyout for Creating Pocketing Operations.
Trochoid Milling
Creates a Trochoid Milling operation.
See Creating a Trochoid Milling Operation.
Curve Following
Creates a Curve Following operation.
See Creating a Curve Following Operation.
Groove Milling
Creates a Groove Milling operation.
See Creating a Groove Milling Operation.
Sweep Helix Following
Creates a Sweep Helix Following operation.
See Creating a Sweep Helix Following Operation.
Point to Point
Creates a Point to Point operation.
See Creating a Point to Point Operation.
Holes or Pins Probing
See Flyout for Creating Holes or Pins Probing Operations.

Flyout for Creating Prismatic Machining Areas

Prismatic Machining Area
Creates a prismatic machining area.
See Creating and Using Prismatic Machining Areas.
Prismatic Rework Area
Creates prismatic rework areas features to rework corners and channels. Corners and channels are quickly identified and then reworked using different operations.
See Creating a Prismatic Rework Area for Corners and Channels.

Flyout for Creating Prismatic Roughing Operations

Prismatic Roughing
Creates a Prismatic Roughing operation.
See Creating a Prismatic Roughing Operation.
Plunge Milling
Creates a Plunge Milling operation.
You can create a Plunge Milling operation with points or by an offset. This operation takes into account the geometrical environment and accepts the definition of both part and stock. If the stock is not defined, the operation uses rework technology to take into account the shape of the stock at the beginning of the operation.
See Using Plunge Milling Operations.

Flyout for Creating Pocketing Operations



Pocketing
Creates a Pocketing operation.
See Creating a Pocketing Operation.


4-Axis Pocketing
Creates a 4-Axis Pocketing operation.
See Creating a 4 Axis Pocketing Operation.

Flyout for Creating Holes or Pins Probing Operations



Holes or Pins Probing
Creates a Holes or Pins Probing operation.
See Creating Probing Holes.


Slots or Ribs Probing
Creates a Slots or Ribs Probing operation.
See Creating Probing Ribs.


Corner Probing
Creates a Corner Probing operation.
See Creating Probing Corners.


Multi-Points Probing
Creates a Multi-Points Probing operation.
See Using Probing with Multi-Points.